Fujitsu fi-6800 - Imprinter Settings [Imprinter Selection]

Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
181
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Imprinter Settings [Imprinter selection]
Specify which imprinter to use when both Front-Side Imprinter
and Back-Side Imprinter are installed.
This setting does not appear when no imprinter is installed.
1 Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page 132).
2 From the listing on the left, click [Device Setting 2] 
[Imprinter selection].
3 Select the Imprinter to use.
Normal
(obey Host specification):
Follows the scanner driver setting.
Forcibly select Front-Side
Imprinter:
Forces the Front-Side Imprinter to be
used unless specified otherwise by
the scanner driver.
Forcibly select Back-Side
Imprinter:
Forces the Back-Side Imprinter to be
used unless specified otherwise by
the scanner driver.
 For information about the Imprinter, refer to "A.4
Scanner Options" (page 188).
 This setting can also be configured from the scanner
driver’s setup dialog box. When [Normal (obey Host
specification)] is selected, priority is given to the
scanner driver settings. When [Forcibly select Front-
Side Imprinter] or [Forcibly select Back-Side Imprinter]
is selected, priority is given to Software Operation
Panel settings.