Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
148
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Specifying the Cycle to Replace Consumables
[Life Counter Alarm Setting]
You can specify the replacement cycle of the consumables.
The background color of the counter changes to light yellow
when the page count after replacing the consumable reaches
95% of the value specified here, and turns yellow when it
reaches 100%. You can also display the message for
replacing consumables (page 147).
1 Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page 132).
2 From the listing on the left, select [Device Setting 2]
[Life Counter Alarm Setting].
3 Specify a value for the life cycle for replacing each
consumable (Pick roller, separator roller and brake roller).
The specifiable value is from 10,000 to 2,550,000 in increments of
10,000.
To Next Page
Loading...
