Fujitsu fi-6800 - Resuming from Power Saving Mode

Index
Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Contents
TOP
26
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Power saving mode saves the power consumption of the
scanner while the power is turned on.
If the scanner is left powered on for 15 minutes or more
without being used, it automatically enters power saving
mode.
When it enters power saving mode, the LCD on the operator
panel turns off. The power button remains lit in blue.
To resume from power saving mode, perform one of the
following:
 Load a document on the hopper.
 Press any button (except for power button) on the operator panel.
Note that the scanner will be turned off when you press the power
button for more than two seconds.
 Execute a command from the scanner driver.
Also, the scanner can be set to turn itself off automatically
when it is turned on and left unused for a certain period of
time.
You can save the power consumption by having the scanner
turn off automatically.
To enable this setting, select the [Power off after a certain
period of time] check box in [Device Setting] of the Software
Operation Panel. For details, refer to "Setting the Waiting Time
to Enter Power Saving Mode [Power saving]" (page 178).
To turn the scanner back on when it is automatically turned off,
press the power button on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
16).
1.10 Resuming from Power Saving Mode
 Depending on the application you are using, the scanner
may not be turned off automatically even when the [Power
off after a certain period of time] check box is selected.
 If the scanner turns itself off automatically while you are
using an image scanning application, close the application
first, then turn the scanner back on.
The waiting time for entering power saving mode can be
changed in the Software Operation Panel.
For more details, refer to "Setting the Waiting Time to Enter
Power Saving Mode [Power saving]" (page 178).