Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
172
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Settings for Multifeed Detection in Manual
Feeding
[Multifeed detection when scanning in manual
feeding mode]
Configure this setting when you want to enable multifeed
detection for scanning in Manual Feed mode.
1 Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page 132).
2 From the listing on the left, select [Device Setting 2]
[Multifeed detection when scanning in manual feeding
mode].
3 Select a detection method.
Detection Description
Disable Does not detect multifeeds.
Follow driver settings Detects multifeeds if multifeed detection is
enabled in the scanner driver settings.
(Displays [Follow multifeed settings] when
connected via VRS board (optional).)
To Next Page
Loading...
