Fujitsu fi-6800 - Item Configurable in Function Selection

Index
Introduction
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Contents
TOP
67
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Item Configurable in Function Selection
*1: Although there is no factory default setting, it is set to [No.01] when you turn on the power. Therefore, the setting does not change even when you initialize
the operator panel.
Item Description Setting Factory Default
Function
Selection
Configure the application(s) to be launched by the [Send to/
Pause] button.
It displays the scanner button events configured in the computer
([Send to 1] to [Send to 50]).
For information on how to configure scanner button events, refer to
"Using a Button on the Scanner to Start Scanning" (page 76).
Note that this item is not available when using Kofax VRS
(optional).
No.01 to No.50 / No.C
(No.C indicates the Software Operation
Panel)
(*1)