Fujitsu fi-6800 - Images Are Distorted or Not Clear

Index
Introduction
Chapter 7 Troubleshooting
Appendix
Glossary
Contents
TOP
120
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Operational
Settings
Replacing
Consumables
Scanner
Overview
Troubleshooting
Images are distorted or not clear.
Are the glasses and rollers inside the ADF clean?
No
Clean the dirty locations.
For information on how to clean the dirty locations, refer to "Chapter 5 Daily Care"
(page 81).
Ye s
Is the top of the ADF being pushed down during scanning?
Is there a heavy object placed on top of the ADF?
Ye s
Do not press down on the top of the ADF or place any heavy objects on the ADF
during scanning.
No
Is anything causing the scanner to vibrate during
scanning?
Ye s
Do not allow the scanner to vibrate during scanning.
No
Is the scanner placed on a flat and level surface? Also, are
there rubber pads attached on the bottom of the scanner?
No
Either place the scanner on a flat and level surface, or attach the rubber pads on
the bottom of the scanner.
Ye s
If the above countermeasures do not solve the problem, check the items in "7.4
Before You Contact the Scanner Service Provider" (page 128) first, then contact
your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.