Index
Introduction
Chapter 7 Troubleshooting
Appendix
Glossary
Contents
TOP
126
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Operational
Settings
Replacing
Consumables
Scanner
Overview
Troubleshooting
Scanned images turn out elongated.
*1: "Consumables" refers to the pick roller, separator roller and brake roller.
Are the rollers dirty?
Ye s
Clean the rollers.
For more information on cleaning, refer to "5.2 Cleaning the ADF (with Cleaning
Sheet)" (page 84) or "5.3 Cleaning the ADF (with cloth)" (page 86).
No
Does the condition of the documents fulfill the
requirements described in "Precautions" in "Paper Quality"
(page 37)?
No
Use a document that satisfies the required conditions.
For more details, refer to "2.2 Documents for Scanning" (page 37).
Ye s
Are any of the consumables (*1) worn out?
Ye s
Check the consumable counters. Replace the consumables if necessary.
For information on how to replace consumables, refer to "Chapter 6 Replacing
Consumables" (page 93).
No
Have you adjusted [Offset/Vertical Magnification
Adjustment]?
No
In [Hardware Setting] of the Software Operation Panel, adjust the scan scale in the
feeding direction.
For more details, refer to "Adjusting the Starting Position for Scanning [Offset/
Vertical Magnification Adjustment]" (page 149).
Ye s
If the above countermeasures do not solve the problem, check the items in "7.4
Before You Contact the Scanner Service Provider" (page 128) first, then contact
your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.
To Next Page
Loading...
