Fujitsu fi-6800 - Page 107

Index
Introduction
Chapter 7 Troubleshooting
Appendix
Glossary
Contents
TOP
107
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Operational
Settings
Replacing
Consumables
Scanner
Overview
Troubleshooting
J0:52 Paper jam
Remove the document and try
again.
1 Remove the jammed
document(s). For
information on how to
remove documents, refer
to "7.1 Paper Jam" (page
103).
2 Check if the documents
are suitable for scanning
by ADF.
For more details, refer to
"2.2 Documents for
Scanning" (page 37).
3 Clean the rollers.
For more details, refer to
"Chapter 5 Daily Care"
(page 81).
J3:54 Skew detected
Remove the document and try
again.
1 Remove the jammed
document(s). For
information on how to
remove documents, refer
to "7.1 Paper Jam" (page
103).
2 Make sure that the hopper
side guides are not set
too wide.
Error
code
Error message Countermeasure
J2:55 Multifeed detected (Overlap)
Press the iMFF button to eject
the document and to suppress
multifeed detection from next
scans. Press the Eject button
just to eject the document.
When [Ready] is displayed,
increase the paper separation
force by using the [] button
to suppress multifeeds. (*1)
When you press the [Eject]
button on the operator
panel, the multifed
documents are ejected.
Multifeed detected (Overlap)
Press the Eject button to eject
the document.
When [Ready] is displayed,
increase the paper separation
force by using the [] button
to suppress multifeeds. (*1)
Error
code
Error message Countermeasure