Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
134
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Item Description Setting/Value Factory Default SCSI or USB
Connector
VRS board (optional)
connection
: Configurable
Sheet count Check the replacement cycle of the
consumables and the total page
count of the maintenance parts.
Also use it to reset the counter
when you have replaced the
consumables or performed
cleaning.
Total Page Count(ADF) / After cleaning /
Brake Roller / Pick Roller / Separator
Roller / Assist Roller
0
Ink Level:Front / Ink Level:Back
(only when imprinter is installed)
Only displayed
when imprinter is
installed
Power saving Specify the waiting time before
entering power saving mode.
Range: 5 min. to 235 min. (in increments of
5 min.)
15 min.
Power off after a certain period of
time: Select to have the scanner
turn off automatically when it is
turned on and left unused for a
certain period of time. Also, specify
the time until power-off.
[Power off after a certain period of time]
check box
(*1)
1 Hour/2 Hours/4 Hours/8 Hours
(when the above check box is selected)
Offset Setting Adjust the position to start
scanning for the specified
scanning side(s).
SCSI or USB Connector:
ADF(Front) / ADF(Back)
VRS board (optional) connection:
ADF(Back)
Main/Sub: -2 to 3 mm
(in increments of 0.5 mm)
Main/Sub: 0 mm
Vertical
magnification
Adjustment
Adjust the magnification level in
feeding direction for the specified
scanning method.
Applied to: ADF
Setting range: -3.1 to 3.1% (in increments
of 0.1%)
0%
To Next Page
Loading...
