Fujitsu fi-6800 - Page 48

Index
Introduction
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Contents
TOP
48
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Indicates that a recoverable error
occurred during scanning.
Error codes beginning with the
letter "J" or "U" are displayed.
For more details about the
errors, refer to "Temporary
Errors" (page 106).
You can clear the error display by
pressing the [Clear/Back] or the
[Stop] button.
Note that if the error is “Paper
jam”, the message disappears
after a certain amount of time
elapses with no documents
([Ready] status) in the scanner.
Indicates that a device error
occurred during initialization or
scanning.
Error codes beginning with the
letter "E", "F", "C", "H", "A" or "L"
are displayed.
For more details about the
errors, refer to "Device Errors"
(page 109).
When this indication of a device
error is displayed, turn the power
off then back on from the main
power switch.
If the indication continues to
appear after turning the power
back on, contact your FUJITSU
scanner dealer or an authorized
FUJITSU scanner service
provider.
Display Description
Error code
Error
Message
Error code
Error
Message
When the scanner has not been
in operation for the set sleep
interval, it enters power saving
mode.
Press any button on the operator
panel to return to the previous
screen.
Display Description