Index
Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Contents
TOP
74
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Various Ways
to Scan
How to Use
the Operator
Panel
5 Repeat step 4 until all the documents are scanned.
■ Scanning in Continuous Feed mode
1 Open the hopper if it is closed.
For information on how to open the hopper, refer to "1.4 Opening/
Closing the Hopper" (page 18).
2 Configure by selecting [Main Menu] [10: Hopper Level]
[1: Manual (Continuous)] on the operator panel.
For more details about the setting, refer to "3.2 Main Menu" (page
50).
The hopper moves up to the feeding position.
3 Load the documents on the hopper with the front side
(scanning side) facing up.
Make sure not to place the documents all the way in.
4 Scan the document with the image scanning application.
For details, refer to the image scanning application manual.
Scanning can be stopped immediately by pressing the
[Counter Reset] button on the operator panel.
Scanning stops when no document is loaded on the
hopper after the time specified in the Software
Operation Panel.
The scanner waits for the period of manual feed
timeout even when there is no document left on the
hopper.
The timeout period for manual feeding can be
configured on the operator panel or in the Software
Operation Panel.
To release Manual Feed mode, bring the pick roller
unit back down to its original position. Put your finger
on the tab in the center and push it down.
Make sure that there is no document left on the
hopper.
Be careful not to have your fingers or anything else
caught when the hopper moves up.
You can also set it to [Manual (Continuous)] from the
[Hopper Level] screen via shortcut key. For details about
the setting, refer to "1.7 Setting the Loading Capacity of
the Hopper" (page 22).
To Next Page
Loading...
