Index
Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Contents
TOP
79
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Various Ways
to Scan
How to Use
the Operator
Panel
Settings to configure before using this function
Before using this function, configure [Check Overlapping (Ultrasonic)] or
[Check Overlapping and length] for multifeed detection method by
performing one of following:
Configure the setting in the scanner driver. For details, refer to the
scanner driver's Help.
Operational procedure
1 After a multifeed error occurs, either press the [Eject]
button to eject the document from the paper path, or open
the ADF to remove the document.
When the document is removed, the display on the operator panel
LCD changes as follows:
Upon multifeed Upon ejecting
document
Multifeed detected (Overlap)
Press the iMFF button to eject the document and
to suppress multifeed detection from next scans.
Press the Eject button just to eject the document.
When [Ready] is displayed, increase the paper
separation force by using the [] button to
suppress multifeeds. (*1)
[Ready
(Multifeed)]
screen
Multifeed detected (Overlap)
Press the Eject button to eject the document.
When [Ready] is displayed, increase the paper
separation force by using the [] button to
suppress multifeeds. (*1)
Multifeed detected (Overlap)
Press the iMFF button to memorize the multifeed
pattern and eject the document. Press the Eject
button to eject the document.
When [Ready] is displayed, increase the paper
separation force by using the [] button to
suppress multifeeds. (*1)
Multifeed detected (Overlap)
Press the iMFF button to memorize the multifeed
pattern. Press the Eject button to eject the
document.
When [Ready] is displayed, increase the paper
separation force by using the [] button to
suppress multifeeds. (*1)
Multifeed detected (Length)
Press the Eject button to eject the document.
[Ready] screen
To Next Page
Loading...
