Fujitsu fi-6800 - Page 9

Index
Appendix
Glossary
Introduction
Contents
TOP
Contents
9
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Operational
Settings
Replacing
Consumables
Scanner
Overview
Daily Care
Troubleshooting
7.4 Before You Contact the Scanner Service
Provider ............................................................128
General............................................................... 128
Error Status ........................................................ 128
7.5 Checking the Product Labels .........................130
Location.............................................................. 130
Chapter 8 Operational Settings ....................... 131
8.1 Starting Up the Software Operation Panel ....132
8.2 Configurable Items ..........................................133
Device Setting .................................................... 133
Device Setting 2 ................................................. 136
8.3 Settings Related to Sheet Counters ..............145
Checking and Resetting the Counters................ 145
Specifying the Cycle to Clean the Scanner
[Cleaning Cycle].............................................. 147
Specifying the Cycle to Replace Consumables
[Life Counter Alarm Setting]............................ 148
8.4 Settings Related to Scanning .........................149
Adjusting the Starting Position for Scanning
[Offset/Vertical Magnification Adjustment] ...... 149
Eliminating Shadows or Streaks on the Scanned
Image Edge [Page Edge Filler (ADF)] ............ 151
Eliminating Shadows or Streaks on the Scanned
Image Edge [Page Edge Filler (Automatic Page
Size Detection)]............................................... 152
Specifying a Color to Drop Out
[Dropout color] ................................................ 153
Specifying Custom Color(s) to Drop Out
[Multi dropout colors]....................................... 154
Shortening the Scanning Intervals [Pre-Pick]..... 156
Specifying the Number of Feeding Retries
[Number of paper feeding retries] ................... 157
Specifying the Interval to Feed the Documents
[Set the interval for feeding sheets] ................ 157
Setting the Speed to Feed the Documents
[Pick Speed].................................................... 158
Paper Feeding Operation Setting
[Soft Pick Setting]............................................ 159
Cropping the Image Boundary
[AutoCrop Boundary] ...................................... 160
Setting Automatic Detection for Color/
Monochrome [Auto color Detection]................ 161
Sounding an Alarm When an Error Occurs
[Alarm setting]................................................. 162
Detecting Paper Jam outside of Scannable Area
[Jam Detection outside of scannable area
when transporting paper] ................................ 163
Setting for a Function to Save the Documents
from Being Damaged [Paper Protection] ........ 164
Specifying the Sensitivity Level for Paper
Protection [Paper Protection Sensitivity]......... 165
Scan Settings for Documents with Tabs/
Non-rectangular Documents
[Scan Setting for Document with Tab
(Automatic Page Size Detection)]................... 166