Fujitsu fi-6800 - Page 98

Index
Chapter 6 Replacing Consumables
Appendix
Glossary
Introduction
Contents
TOP
98
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing
Consumables
4 Pull the lever on the left side of the separator roller towards you,
and remove it with the shaft.
4 Install a new separator roller on the scanner.
1 Install the separator roller. Insert the right side of the shaft first,
then the left side so that the tab fits in the groove.
2 Push up the lever which is located on the left side of the separator
roller.
3 Push up the lever which is located on the right side of the
separator roller.
2
1
Separator Roller
Ta b
2
1
Separator Roller
Separator Roller
Lever
Separator Roller
Lever