Fujitsu fi-7140 - Situation in Which the Document Is Not Fed into the ADF Occurs Frequently

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
111
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
Situation in which the document is not fed into
the ADF occurs frequently.
*1: "Consumables" refers to the brake roller and the pick roller.
Do the documents meet the requirements described in
"Precautions" in "Conditions" (page 41)?
No
Use documents that meet the requirements.
For details, refer to "2.3 Documents for Scanning" (page 41).
Yes
Did you fan the documents before loading them in the ADF
paper chute (feeder)?
No
Fan the documents before loading them. Or reduce the amount of documents.
Yes
Are the consumables
(*1) installed correctly?
No
Install the consumables (*1) correctly.
For details, refer to "Chapter 6 Replacing the Consumables" (page 83).
Yes
Are the consumables
(*1) clean?
No
Clean the consumables (*1).
For details, refer to "Chapter 5 Daily Care" (page 72).
Yes
Are the consumables
(*1) worn out?
Yes
Check the consumable counters and replace them if necessary.
For details, refer to "Chapter 6 Replacing the Consumables" (page 83).
No
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 119) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.