Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
116
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
The Carrier Sheet is not fed smoothly./Paper jams
occur.
Did you scan just the Carrier Sheet continuously?
Yes
Feed about 50 sheets of PPC paper (recycled paper) before scanning with the
Carrier Sheet.
The PPC paper can either be blank or printed.
No
Is the Carrier Sheet clean?
No
Perform one of the following.
Clean the Carrier Sheet.
For details, refer to "Chapter 5 Daily Care" (page 72).
Replace the Carrier Sheet.
For information on purchasing the Carrier Sheet, contact your FUJITSU
scanner dealer or an authorized FUJITSU scanner service provider.
Yes
Did you start the scan after loading the Carrier Sheet in the
ADF paper chute (feeder)?
No
Start the scan after loading the Carrier Sheet in the ADF paper chute (feeder).
For details, refer to "Documents Larger than A4/Letter Size" (page 57) or
"Scanning Photographs and Clippings" (page 59).
Yes
Are the glass and rollers inside the ADF clean?
No
Perform cleaning.
For details, refer to "Chapter 5 Daily Care" (page 72).
Yes
Are the consumables (*1) worn out?
Yes
Check the consumable counters and replace them if necessary.
For details, refer to "Chapter 6 Replacing the Consumables" (page 83).
No
Is there any foreign matter inside the ADF?
Yes
Clean the ADF. If there is any foreign matter in the ADF, remove it.
For details, refer to "Chapter 5 Daily Care" (page 72).
No
To Next Page
Loading...
