Contents
Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
43
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
HINT
When scanning semi-transparent documents, increase the
brightness for scanning to avoid bleed-through.
When you scan documents written in lead pencil, make sure to clean
the rollers frequently. Otherwise, the rollers will be contaminated
which may leave black traces on the document or cause feeding
errors.
For details about cleaning, refer to "Chapter 5 Daily Care" (page 72).
If multifeeds, pick errors, or paper jams occur frequently, refer to "7.3
Troubleshooting" (page 99).
When you scan documents with the ADF, all documents must be flat
on the leading edge. Make sure that curls on the leading edge of the
documents are kept within the following range:
30 mm or more
Feeding direction
3 mm
or less
5 mm
or less
30 mm or more
Feeding direction
(0.20 in.)
(0.12 in.)
(1.18 in.)
(1.18 in.)
Leading edgeLeading edge
Scanned side Scanned side
To Next Page
Loading...
