Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
97
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
■Motor Circuit Error
The letter "H" and an alarm number appear alternately.
■Option Error (When Imprinter Is Installed)
The letter "A" and an alarm number appear alternately.
Display Description Action
H0 A motor circuit error
occurred.
Turn the scanner off then back on.
If the problem persists, write down
the displayed error code and contact
your FUJITSU scanner dealer or an
authorized FUJITSU scanner
service provider.
H6 An imprinter circuit
error occurred.
(only when imprinter
is installed)
H7 A lamp circuit error
occurred.
Display Description Action
A0 An imprinter control
board error occurred.
1 Confirm that the EXT cable of
the imprinter is connected
properly to the EXT connector
on the back of the scanner.
For details about the EXT
cable, refer to "Back" (page
16).
For details about how to
connect the EXT cable, refer to
the fi-718PR Imprinter
Operator's Guide.
2 Confirm that the print cartridge
is installed correctly.
For details, refer to the fi-
718PR Imprinter Operator's
Guide.
3 Turn the scanner off then back
on.
If the problem persists, write
down the displayed error code
and contact your FUJITSU
scanner dealer or an
authorized FUJITSU scanner
service provider.
A1 A communication
timeout error occurred
with the imprinter.
A2 A printer head error of
the imprinter occurred.
A3 An imprinter EEPROM
error occurred.
A4 An imprinter ROM error
occurred.
To Next Page
Loading...
