Chapter 6 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
89
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
6 Attach the two new pick rollers on the shaft on at a time.
1 Insert the retaining clip of the pick roller into the slot.
2 Insert the retaining clip of the other pick roller into the slot.
7 Attach the shaft.
1 Insert the left end of the shaft into the slot, and lower the other end
gradually.
2 Rotate the bushing on the shaft in the direction of the arrow.
3 Close the sheet guide. Make sure that both ends of the sheet guide
are locked firmly.
ATTENTION
Confirm that the pick roller is installed properly. Otherwise, it may
cause feeding errors such as paper jams.
Make sure to insert the pick roller until it locks in place.
Shaft
Pick Roller
Retaining Clip
Slot
Shaft
Pick Roller
Retaining Clip
Slot
ATTENTION
Confirm that the pick roller is installed properly. Otherwise, it may
cause feeding errors such as paper jams.
To Next Page
Loading...
