How to Use the
Operator Panel
Various Ways to
Scan
Troubleshooting
Replacing the
Consumables
Daily Care
Operational
Settings
Chapter 5 Daily Care
Appendix
Glossary
Introduction
Index
Contents
TOP
79
How to Load
Documents
Scanner
Overview
Ultrasonic Sensor (× 2)/Document Sensor (× 8)
Gently wipe the dirt and dust off the surface of the ultrasonic/document
sensors.
Feed Roller (× 2)/Eject Roller (× 2)
The power must be turned on to rotate the feed/eject rollers.
1 Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page 23).
2 After "1" is displayed on the Function Number Display on the
operator panel, open the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 25).
3 When you press the [Send to] and [Scan/Stop] buttons on the
operator panel at the same time, the feed/eject rollers rotate a
certain amount.
HINT
If it is difficult to clean, use a cotton swab.
Ultrasonic Sensor
Document Sensor
When the ADF is open, it might close
accidentally. Be careful not to get your
fingers caught.
Be careful not to touch the rollers with your
hand while they are rotating.
Check
Function
Send to
Scan
/Stop
Power
[Send to] Button
[Scan/Stop] Button
To Next Page
Loading...
