Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
133
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Item Description Parameter/Value Factory Default
Multifeed
(page 152)
Specify a method for multifeed detection. Detect
multifeeds by monitoring the overlap, document
length, or the combination of both.
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
None/Check Overlapping (Ultrasonic)/Check
Length/Check Overlapping and Length
Length (When [Check Length] is specified:
Select from 10/15/20 mm)
None
Length: 10 mm
Page Edge Filler (ADF)
Page Edge Filler (FB) (fi-7240)
(page 143)
Specify a width for the margin around the
scanned image to fill the margin in white or
black.
The specified area is filled in white or black,
according to the background color.
This setting can also be configured in the
scanner driver. In that case, Page Edge Filler of
the scanner driver is used on the output image.
ADF:
Top/Left/Right: 0 to 15 mm
Bottom: -7 to 7 mm (in increments of 1)
FB (fi-7240):
Top/Bottom/Left/Right: 0 to 15 mm
(A: image, B: filled area, A+B: output)
Top/Bottom/Left/
Right: 0 mm
Dropout color
(page 145)
Select a color to be removed from the scanned
image (only available in black & white or
grayscale mode).
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
Red/Green/Blue/None Green
Pre-Pick
(page 146)
Select [Yes] to prioritize the processing speed.
Select [No] for otherwise.
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
Yes/No Yes
To Next Page
Loading...
