Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
135
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Cleaning Cycle
(page 140)
Specify the scanner cleaning cycle.
Select whether or not to display the cleaning
instruction message from the scanner driver.
1,000 to 255,000 sheets
(in increments of 1,000)
Show cleaning instructions: Selected/Not
selected
5,000 sheets
Not selected
Life Counter Alarm Setting
(page 140)
Specify the replacement cycle for the
consumables.
Pick Rollers/Brake Rollers:
10,000 to 2,550,000 sheets
(in increments of 10,000)
Pick Rollers:
200,000 sheets
Brake Rollers:
200,000 sheets
Pick Speed
(page 147)
When multifeeds and paper jams occur
frequently, you may be able to improve the
performance by slowing down the speed in
which documents are picked or fed.
Normal/Slow Normal
AutoCrop Boundary
(page 148)
Specify whether or not to optimize (round up/
down) the fractional part of the scanned image
data.
Optimize/Round Down Optimize
Manual-feed timeout
(page 158)
Select whether to disable or enable manual
feeding.
Disable/Enable Disable
Paper-out detection time: Specify the waiting
time to cancel manual feeding.
5, 10, 20, 30, 40, 50, 60, 70, 80, 90, 100, 110
(seconds)
10 seconds
Power SW Control
(page 160)
Specify the method by which the scanner is
powered on/off.
Enable power switch/Disable power switch/
Enable USB power feeding
Enable power
switch
Paper Protection
(page 149)
Select whether to disable or enable paper
protection.
When enabled, this function reduces the risk of
having the documents damaged by stopping
the scan when the scanner detects a document
that is unusually warped when a feeding error
occurs.
In manual feed mode, the paper protection
setting is disabled.
This setting can also be configured in the
scanner driver. Note that the highest priority is
given to the scanner driver setting.
Enable/Disable Enable
Item Description Parameter/Value Factory Default
To Next Page
Loading...
