Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
140
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Scanner Cleaning Cycle [Cleaning Cycle]
The cleaning cycle for the scanner can be specified.
The background color of the cleaning counter (in [Device
Setting]) turns yellow when the page count after cleaning is
performed reaches 100% of the specified value.
You can also display a cleaning instruction message (page 139).
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 123).
2 From the listing on the left, select [Device Setting 2]
[Cleaning Cycle].
3 Specify a value for the cleaning cycle.
The value can range from 1,000 to 255,000 sheets (in increments of
1,000).
Specify whether or not to display the cleaning instruction message.
Replacement Cycle of Consumables [Life
Counter Alarm Setting]
The replacement cycle for each consumable can be specified.
The background color of the brake roller/pick roller counter (in
[Device Setting]) changes to light yellow when the page count
after a consumable replacement reaches 95% of the value
specified here, and turns yellow when the page count reaches
100%.
A message for replacing a consumable (page 139) also
appears.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 123).
2 From the listing on the left, select [Device Setting 2]
[Life Counter Alarm Setting].
To Next Page
Loading...
