Fujitsu fi-7140 - Chapter 6 Replacing the Consumables

Appendix
Glossary
Introduction
Index
Contents
TOP
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
Chapter 6 Replacing the
Consumables
This chapter describes how to replace the consumables for the scanner.
6.1 Consumables and Replacement Cycles.....................................................................................................84
6.2 Replacing the Brake Roller.........................................................................................................................85
6.3 Replacing the Pick Roller ...........................................................................................................................87
The inside of the ADF becomes very hot when the
scanner is being used.
Before you replace the consumables, make sure to
turn off the power, unplug the power cable and wait
at least 15 minutes for the inside of the ADF to cool
down.