Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
145
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Removing a Color from the Scanned Image
[Dropout color]
With "Dropout color", you can select either green, red, or blue
(primary colors) to remove the details of the selected color
from a scanned image.
For example, when scanning a document with black
characters and a green background, you can only scan the
black characters of the document by selecting green for the
dropout color.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 123).
2 From the listing on the left, select [Device Setting 2]
[Dropout color].
3 Select a color to drop out.
Red, Green, Blue: The selected color is dropped out.
None: No color is dropped out.
ATTENTION
Dropout works the best with light (low intensity) colors, and dark colors
may not drop out.
HINT
Dropout color is only available in black & white or grayscale mode.
ATTENTION
The Software Operation Panel allows you to choose the color from
red, green, and blue only. To drop out a color of your choice,
configure the setting in the scanner driver.
For details, refer to the scanner driver's Help.
HINT
This setting can also be configured in the scanner driver. Note that
priority is given to the scanner driver setting.
To Next Page
Loading...
