Stacker
Stacks up the ejected documents.
Operator Panel
Consists of a Function Number Display,
buttons, and LED indicator.
Can be used to operate the scanner or check
the status.
For details, refer to "Chapter 3 How to Use
the Operator Panel" (page 51).
ADF (Automatic Document Feeder)
Pulls and feeds the documents one sheet at a
time from the ADF paper chute (feeder).
Open this to replace consumables or to clean
the inside of the scanner.
Side Guides
Positions the documents in place when the
documents are loaded in the ADF paper
chute (feeder) as they are fed into the
scanner.
Chute Extension 2
Pull out to adjust to the document length.
ADF Paper Chute (Feeder)
Holds the documents to be scanned.
ADF Release Tab
Pull this tab to open the ADF.
Flatbed
For scanning documents (such as thin paper or
books) that cannot be scanned with the ADF.
Chute Extension 1
Pull out to adjust to the document length.
Stopper
Lift up to adjust to the document length.
Transport Lock Switch
Locks the carrier unit (which is inside the
flatbed) to prevent damage during
transportation.
To Next Page
Loading...
