Fujitsu fi-7140 - 1.2 Parts and Functions

Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
15
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section shows the names of the scanner parts.
fi-7140
■Front
1.2 Parts and Functions
Stacker
Stacks up the ejected documents.
Operator Panel
Consists of a Function Number Display,
buttons, and LED indicator.
Can be used to operate the scanner or check
the status.
For details, refer to "Chapter 3 How to Use
the Operator Panel" (page 51).
ADF (Automatic Document Feeder)
Pulls and feeds the documents one sheet at a time
from the ADF paper chute (feeder).
Open this to replace consumables or to clean the
inside of the scanner.
Side Guides
Positions the documents in place when the
documents are loaded in the ADF paper chute
(feeder) as they are fed into the scanner.
Chute Extension 2
Pull out to adjust to the document length.
ADF Paper Chute (Feeder)
Holds the documents to be scanned.
ADF Release Tab
Pull this tab to open the ADF.
Stacker Extension 2
Slide out to adjust to the document
length.
Chute Extension 1
Pull out to adjust to the document length.
Stacker Extension 1
Slide out to adjust to the document length.
Stopper
Lift up to adjust to the document
length.
Stacker Stand
Used to adjust the tilt of the stacker.