How to Use the
Operator Panel
Various Ways to
Scan
Troubleshooting
Replacing the
Consumables
Daily Care
Operational
Settings
Chapter 5 Daily Care
Appendix
Glossary
Introduction
Index
Contents
TOP
78
How to Load
Documents
Scanner
Overview
3 Clean the following locations with a cloth moistened with
Cleaner F1 or a sheet of Cleaning Wipe.
Brake Roller (× 2)
Remove the roller from the scanner.
For details about removing the brake roller, refer to "6.2 Replacing the
Brake Roller" (page 85).
Gently wipe off any dirt or dust along the grooves, taking care not to
damage the roller surface.
Pick Roller (× 2)
Gently wipe off any dirt or dust along the grooves as you rotate the roller
manually, taking care not to damage the roller surface. Make sure that it
is wiped properly because black residue on the roller will affect the
feeding performance.
Plastic Idler Roller (× 4)
Gently wipe off any dirt or dust on the surface of the rollers. Make sure
that it is wiped properly because black residue on the roller will affect the
feeding performance.
Be careful not to damage the sponge that is attached to the middle of
the roller.
Glass (× 2)
Gently wipe the dirt and dust off the surface of the glass sections.
Glass (× 2)
Pick Roller
(× 2)
Ultrasonic Sensor (× 2)
Plastic Idler
Roller
(× 4)
Feed Roller
(× 2)
Eject Roller
(× 2)
Brake Roller
(× 2)
Document
Sensor
(× 8)
ATTENTION
Vertical streaks may appear on the scanned image when the glass is
dirty.
To Next Page
Loading...
