Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
134
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Document check area
specification for Multifeed
Detection
(page 154)
Selected range: Select this item to restrict the
area to run multifeed detection.
[Selected range] check box Not selected
Enable/Disable (Middle): Specify whether to
enable or disable multifeed detection in the
selected area.
Enable/Disable
(When [Selected range] is selected)
Disable
Start (Middle): Specify the start position of the
area in length (mm) from the leading edge of
the document.
0 to 510 mm (in increments of 2) 0 mm
End (Middle): Specify the end position of the
area in length (mm) from the leading edge of
the document.
0 to 510 mm (in increments of 2) 0 mm
Intelligent Multifeed Function
(page 157)
When there is a paper of the same size
attached to a designated location on the page,
configure the scanner to memorize the location
of the attachment and not detect multifeeds for
that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check
Overlapping and length] in either the scanner
driver or the multifeed detection setting in
"Specifying a Multifeed Detection Method
[Multifeed]" (page 152).
Manual mode/Auto mode 1/Auto mode 2 Manual mode
Select to clear the overlap pattern (length,
location) memorized in Auto mode.
[Clear overlap pattern] check box Not selected
Select to record the multifeed pattern on the
window to check an image that is detected as
multifeed.
[Auto-Memorize MF Pattern] check box (only
when MF images are displayed)
Not selected
Specify whether or not to memorize the
multifeed pattern upon power-off.
Remember/Do not remember Do not remember
Number of paper feeding retries
(page 147)
Configure this setting to change the number of
feeding retries when a pick error occurs.
1 to 12 times 3 times
Item Description Parameter/Value Factory Default
To Next Page
Loading...
