Fujitsu Primergy RX300 S2 Options Guide

RX300 S2 Options Guide 101
14 Converting from low-profile to
standard PCI Slots
V CAUTION!
Observe the safety instructions in the chapter „Safety notes“ on page 15.
14.1 Removing lp slot cage
Ê Open the server as described in the chapter „Preparation“ on page 21.
Figure 84: Removing hot-plug cable
Ê Release and remove the hot-plug cable from the system board.

Fujitsu Primergy RX300 S2 Specifications

General

Processor Sockets	2
Chipset	Intel 5000P
Network	2 x Gigabit Ethernet
Form Factor	2U Rackmount
Processor	Intel Xeon 5000/5100/5300 series
Storage	SAS or SATA HDD 2.5"/3.5"
RAID Support	Optional RAID controller
Operating System Support	Windows Server, Linux
Power Supply	Redundant power supply optional