RX300 S2 Options Guide 39
Processors Replacing the processor
6.2 Replacing the processor
V CAUTION
Only processors of the same type may be used on the system board. The
second processor must have the same clock frequency and the same
cache as the first processor. For dual operation, use a suitable multipro-
cessor operating system.
Ê Open the server as described in the chapter „Preparation“ on page 21.
Ê Remove the air duct over the main memory and the processors (see
page 28.
Figure 19: Removing the heat sink
Ê Loosen the four screws in a crossover pattern.
Ê Loosen the heat sink by turning it back and forth and then lift it out.
To Next Page
Loading...
