What to do if a Fujitsu Primergy RX300 S2 Server cannot read data from the CD-ROM?
If your Fujitsu Server cannot read data from the CD-ROM, check the following: * Ensure the CD-ROM is inserted properly. * Verify the CD-ROM is clean. * Make sure the CD-ROM is not scratched or bent.
What to do if my Fujitsu Primergy RX300 S2 Server cannot write to the floppy disk?
If your Fujitsu Server cannot write to the floppy disk, the write protection of the floppy disk may be applied. Flip the switch on the disk to allow writing.
What to do if Fujitsu Server unit does not operate properly (SCSI Device Internal/External)?
If your Fujitsu Server unit does not operate properly with a SCSI device (internal/external), check the following: * Ensure the internal cable is connected properly. * Verify that the SCSI IDs and terminator are set correctly.
General| Processor Sockets | 2 |
|---|---|
| Chipset | Intel 5000P |
| Network | 2 x Gigabit Ethernet |
| Form Factor | 2U Rackmount |
| Processor | Intel Xeon 5000/5100/5300 series |
| Storage | SAS or SATA HDD 2.5"/3.5" |
| RAID Support | Optional RAID controller |
| Operating System Support | Windows Server, Linux |
| Power Supply | Redundant power supply optional |
To Next Page
