8 Options Guide U41593-J-Z156-2-76
Extensions and conversions Introduction
RemoteView
RemoteView provides you with a comprehensive test and diagnostics package.
The test and diagnostics software is stored on a chipDISK. The chipDISK is a
memory component with an IDE interface. In the event of a fault the test and
diagnostics software is automatically loaded from the chipDISK and executed.
RemoteView Service Board S2 LP
The RemoteView Service Board S2 LP (RSB S2 LP) is a PCI board with a
completely independent system, i.e. it has its own operating system with Web
server and SNMP agents and can optionally be equipped with an external
power supply. The RSB S2 LP is inserted into PCI slot 5 and connected to the
system board via a power and a data cable. The RSB S2 LP permits remote
diagnosis for system analysis, remote system configuration and remote restart
even in the event of operating system failure or hardware faults. It has its own
LAN connection and its own COM port. All the functions of the RSB S2 LP are
thus available either via a LAN or modem.
External SCSI interface
If the internal hard disks are connected via a PCI RAID controller, one channel
of the on-board controller can also be made available for connecting peripheral
cabinets via an external SCSI interface.
Parallel interface for printers
As an option, a parallel interface can be provided for printers.
Upgrading to redundant system fans
The two system fans can be upgraded to four system fans. If four system fans
are installed, the fans are operating in a redundant configuration. A defective
system fan can be replaced during the next service.
Conversion standard power supply to hot-plug power supply
The standard power supply can be replaced by a hot-plug power supply. The
hot-plug power supply consists of two power supply modules.
If one power supply module fails, the other power supply module guarantees the
unrestricted operation and the defective power supply module can be replaced
be replaced while the system is operating (hot-plug).