Fujitsu ScanSnap iX500

Preparations for Connecting the ScanSnap via
Wireless LAN (iX500 / iX100)
To connect the ScanSnap via wireless LAN, prepare the following:
l An environment in which a wireless LAN is available
To connect the ScanSnap and a computer or a mobile device in Access Point Connect mode,
prepare the wireless LAN environment.
When connecting the ScanSnap to a wireless access point, you may need information such as
an SSID (network name) and a security key (password).
For details, refer to the manual for the wireless access point.
ATTENTION
- Do not place the following within 100 mm (3.9 in.) of the ScanSnap, or near your wireless
access point.
l Obstacles that block radio waves (such as walls and metal plates)
l Devices that may cause signal interference (such as microwaves and cordless phones) and
wireless devices
- If the wireless access point has two types of SSID (2.4 GHz and 5 GHz), the 2.4 GHz SSID
needs to be used.
l ScanSnap Connect Application
To connect the ScanSnap and a mobile device, you need to install ScanSnap Connect
Application on your mobile device.
Download ScanSnap Connect Application for the mobile device from the following application
stores:
- App Store
- Google Play
- Amazon Appstore
Preparations for Connecting the ScanSnap via Wireless LAN (iX500 / iX100)
130