Fujitsu ScanSnap iX500

Checking the MAC address of the ScanSnap (iX1600 / iX1500)
Check the MAC address of the ScanSnap on the touch panel.
1. Press in the home screen on the touch panel of the ScanSnap to
display the [Settings] screen.
2. Press
to display the [Wi-Fi settings] screen.
3. Check that [Wi-Fi connect mode] is set to [Access point connection] or
[Direct connection].
If [Wi-Fi connect mode] is set to [Wi-Fi off], press [Wi-Fi connect mode] and set it to [Access
point connection] or [Direct connection]
4. Press [Wi-Fi information] to display the [ScanSnap information] screen.
5. Check the [MAC address] in the [Network] tab.
Registering a Certificate/ Checking the Wireless LAN Settings (iX1600 / iX1500)
152