Furuno FS-5000 - How to Update Programs; Terminal Program

DP-6
D2-10
6. How to Update Programs
6.1 Terminal Program
Note) The program floppy disk supplied contains both the terminal and main (main
unit) programs.
1. Quit the terminal program.
With the terminal program version -16 or later,
- press [F2]while pressing [Alt] and [Fn] keys.
With the version -15 or earlier,
- press [F2] while pressing [Fn] key.
The prompt, "A:
\
>DP10\TERMINAL>", will appear on the screen.
Note) When updating the terminal program of Ver.-11 or prior, delete "DP10.SAV"
file in advance.
1) Quit the terminal program. "A:\>DP10\TERMINAL>" will appear.
2) Confirm the above file, DP10.SAV
- Press [D], [I], [R], and [Enter] keys successively.
3) Files in "A:\>DP10\TERMINAL>" directory will shown.
4) If there is "DP10.SAV" file, delete it as follows.
- Press [D], [E], [L], [Space], [D], [P], [1], [0], [.], [S], [A], [V], and
[Enter] key successively.
2. Insert the floppy disk containing the terminal program into the FD drive.
3. Change to "B" drive by pressing keys,
- [B], [:], and [Enter], successively.
The prompt, "B:\>", will appear on the screen.