Furuno FS-5000 - Terminal Setup: [F6]; Updating a Distress Alert: [F10]

FELCOM 10
G1-2
*Nav port Auto
*DTE 2 Port Sub -addr. 001
*Message Output Port DTE1
*Polling Output Port DTE1
2.2 Terminal setup: [F6]
1.Press [F6] to display the Terminal menu.
2. Set the “DET Type” to Main.
2.3 Updating a Distress Alert: [F10]
1. Press [F10] key, and [2] key. The display should look like below. Necessary settings
are as below.
*Set the CES ID
The default CES ID is a current NCS (Factory setting is 144, AOR-ENCS).
Tap the Space Bar to display the LES ID list. Select a suitable CES by the [↓]
key followed by the [Enter] key.
*Protocol
Select “Maritime”.
*Nature
Set to “Unspecified”.