FELCOM 82
H3-57
Erase Wait:0sec
Wait:o
Wait counter=200
Port no.=1
TARGET POWER ON.
6. Plug the handset when “TARGET POWER ON” appears.
7. The program upgrading proceeds while the indication “xxx percent completed”
on the screen. If not, press [C] key while holding down [Ctrl] key for the prompt
of A:¥>, and then proceed from step 1.
8. Wait until the message “Finish version up” appears.
9. Turn off the IB-282 and a PC.
10. Turn on the IB-282 to check the program revision level.
4.4 Upgrading terminal program
To upgrade terminal program;
1. Press [Fn], [Alt], and [F2] simultaneously to terminate FELCOM B system
program.
“OK to quite system?” appears. Move the cursor to Yes and press [Enter] key.
Prompt C:¥> sappears.
2. Inset the floppy disk having new terminal software into the drive.
3. Type A: and press [Enter] key. Prompt changes to A:¥>.
4. Type INSTALL and press [Enter] key.
5. The program upgrading proceeds and DOS prompt display comes after upgrading
is completed.
6. Turn off the unit and turn it on again. to
7. Press [F1] while pressing and holding down [Alt] and [Fn] to read the program
version level.
To Next Page
Loading...
