Furuno FS-5000 - How to Update the Terminal and CPU-2 Program; Terminal

FELCOM 12
G3-8
7. How to update the Terminal and CPU-2 program
7.1 Terminal
1. Quit the terminal program.
- Press [F2] key while pressing [Alt] and [Fn] keys.
2. After a message "OK to quit system? Yes/No" has appeared,
- place the cursor on "Yes" and press [Enter] key.
A prompt "A:\FELCOM12>" will appear.
3. Insert the floppy disk containing the terminal program into the FD drive.
4. Change to "B" drive by pressing keys,
- [B], [:], and [Enter], successively.
The prompt, "B:\>", will appear on the screen.
5. To update the terminal program,
- press [I], [B], [I], [N], [S], [T], and [Enter] keys, successively.
Reference) When installing terminal program for Russian:
(1) Successively press keys,
- [I], [B], [R], [I], [N], [S], [T], and [Enter].
(2) Pressing [Alt] key while pressing left [Shift] key, alternates the language for
composing messages between English and Russian.
6. Then, the updating will be finished, displaying the prompt "B:\>".
7. Turn off once and on again the terminal unit.
Confirming program version
With terminal prgram versin -03 after or later :
To confirm the version of the terminal program,
- press [F1] key while pressing [Alt] and [Fn] keys.