Furuno FS-5000 - Page 385

FELCOM 82
H3-56
A:
¥
>uppg load.bin syscpu.bin 0 0 200 1
Program upload utility Version 6.21
Copyright(c) FURUNO ELECTRIC CO.,LTD.1997,1998,1999(T.K)
uppg infile1 infile2 p1 p3 p2 p4 p5
p1:Deletion waiting time.
p2:Waiting time to write.
p3:Password output interval.
p4:ID number.
p5:Port number.(1,2...)
Erase Wait:0sec
Wait:o
Wait counter=200
Port no.=1
TARGET POWER ON.
6. Plug the handset when “TARGET POWER ON” appears on the IB-582 (581).
7. The program upgrading proceeds while the indication “xxx percent completed”
on the screen. If upgrading does not commence, press [C] key while holding
down [Ctrl] key for the prompt of A:¥>, and then proceed from step 1.
8. Wait until the message “Finish version up” appears.
9. Turn off the IB-282 and IB-582 (581).
10. Turn on the IB-282 to check the program revision level.
4.3.2 Using PC
To upgrade the program by using a PC, follow the steps below.
1. Unplug the handset.
2. Run the DOS on the PC.
3. Inset the floppy disk having new handset program into the drive.
4. Type A: and press [Enter] key. Prompt changes to A:¥>.
5. Type UPHAND and press [Enter] key. The following data appears in turn.
A:
¥
>uppg load.bin syscpu.bin 0 0 200 1
Program upload utility Version 6.21
Copyright(c) FURUNO ELECTRIC CO.,LTD.1997,1998,1999(T.K)
uppg infile1 infile2 p1 p3 p2 p4 p5
p1:Deletion waiting time.
p2:Waiting time to write.
p3:Password output interval.
p4:ID number.
p5:Port number.(1,2...)