DSC-5
B1-4
9. You can change (set) following settings.
*Selection (VHF or MF/HF) of communication equipment.
[SETUP] - [4]
*”COMM” setting in the PROG menu.
[SELECT] - [PROG] --- [COMM]
*Tx-key timing setting in the “SYS” sub menu.
[SELECT] - [PROG] - [SYST] --- “key”
*Further, ”TO” (Test tone) in the self test can be done.
[SELECT] [PROG] [TEST] --- “TO”
Refer to Setting List for details.
10. After changing the settings, set the “Ignore ID” in the “TO” test to “OFF” for
normal operation by taking the steps below.
TEST
Watch
[SELECT]
[ENT]
[ENT]
CALL ----- PROG
TIME ----- TEST
[ENT]
NARK ----- ID
[ENT]
MO TO -----
Self test < >
[ENT]
ON OFF
Ignore ID < >
Returns to default display
Select "PROG"
Select "TEST"
Select "TO"
Select "ID"
Select "OFF"
Important !!
To Next Page
Loading...
