Normal Curve Idle-up 1 Curve Idle-up 2 Curve
●Throttle Curve (Example)
The curves shown below were created by using
the Line mode and inputting the data of the 5 points
0% (low side), 25%, 50% (center), 75%, 100%
(high) side at each condition. They were created by
reducing the number points of the line to 5. When
actually creating a curve, enter the data specified
per the fuselage (or the reference value).
*For a description of the curve creation method, see the
description at the back of this manual.
Curve setting examples
● Return to Model Menu
Throttle Hover trim
The Throttle Hover trim setup screen can be called from the THR Curve setup screen.
● Sets Throttle Hover trim.
● Sets the dial used.
The Throttle Hover function trims the throttle
near the hovering point. Normally, use it with
hovering conditions. Changes in rotor speed
accompanying changes in the temperature,
humidity, and other flight conditions can be
trimmed. Adjust the throttle so that rotor rotation is
most stable. More delicate trimming is also possible
by using this function along with the Hover Pitch
function.
Setting method
● When using the hovering (normal) condition
only, switch the [Gr.](group button) mode to the
[Sngl](single) mode and make the settings.
● Set the function to ACT ([ON]).
● Select the adjustment knob. Selection example: RD
● The trim operation mode (Mode: CTRM/NORM)
can be selected.
CTRM mode: Maximum rate of change near
center by center trim operation
NORM mode: Normal trim (horizontal movement
trim) operation. The advantage of using this mode
is that hovering throttle can be adjusted without
changing the curve.
● Trim adjustment range (Range) setting
When the value is made small, trim acts only near
the center.
● The trim rate can be adjusted and the operation
direction can be set.
112
<Model Menu (Helicopter Functions)>
To Next Page
Loading...
