PIT to Needle mixing
This mixing is used when the engine is equipped
with needle control or other fuel-air mixture
adjustment. A needle curve can be set.
An acceleration function which temporarily
increases needle operation at throttle stick
acceleration/deceleration operation can be set.
The rise characteristic of the needle servo at
acceleration and deceleration operation can be
adjusted.
● Return to Model Menu
● Touch the [PIT to Needle] button in the Model
Menu to call the setup screen shown below.
Setting method
●When using this function, touch the [INH] button
and display [ON] or [OFF].
●When you want to set the same contents at other
conditions, select the group mode (Gr.). When
you want to set the selected condition only, select
the single mode (Sngl).
●A needle curve can be set.
●A switch can be set.
When [NULL] is set, the function is operated by
merely selecting the condition.
When setting and [ON]/[OFF] switch, touch the
[NULL] button and set the switch and its ON
direction at the <Switch> screen.
< Acceleration function setting>
●Acceleration can be set at both setting
at acceleration (High) and setting at
deceleration (Low).
●The acceleration rate (Rate) and the return
time after operation (Dump.) can be set.
●An operation point (Operation Point) at
acceleration and deceleration can be set.
When an operation point was exceeded,
acceleration operation is performed.
● Normally, use [Line] type.
117
<Model Menu (Helicopter Functions)>
To Next Page
Loading...
