Operation direction reversal method
1. Touch the setting button corresponding to
the H/W (Hardware) you want to reverse.
2. Reverse the H/W by touching [Yes]. (When
you want to stop operation, touch [No].)
[Normal]: Normal operation direction
[Reverse]: Reverses the operation direction.
H/W Reverse
Stick, switch, trim lever, and knob operation direction reversal (Hardware reverse)
This function reverses the operation signal of the
sticks, switches, trimmer levers, and knobs.
● Touch the [H/W Reverse] button at the System
Menu to call the setup screen shown below.
●Return to System Menu
Note: This setting reverses the actual operation
signal, but does not change the display of
the indicators on the display. Use the Normal
mode as long as there is no special reason to
use the Reverse mode.
37
<Functions of System Menu>
To Next Page
Loading...
