Connector/Plug
●DSC/Trainer●Audio/
Battery Charge
Connector for trainer function (TRAINER)
When you use trainer function, connect the
optional trainer cable between the transmitters for
teacher and student.
*You can set the trainer function on the Trainer Function
screen in the system menu.
Connector for DSC function (DSC)
You can operate the transmitter without
transmitting radio waves by connecting the
transmitter and the receiver to the DSC cable.
*Please refer to the section "Connection between Receiver/
Servo"
Audio plug (PHONE)
Connecting a stereo headphone to this plug, you
can enjoy music fi les stored in the CF card.
Connector for battery charger (CHG)
This is the connector for charging the Lithium
Ion battery LT2F2200 that is installed in the
transmitter. Do not use any other chargers except
CR-2500 that is for 12V application to charge the
LT2F2200 battery through this connector.
Danger
Do not connect any other chargers except
CR-2500 to this charging connector.
*If you take out the Lithium Ion battery LT2F2200 from the
transmitter, you can use the attached charger LBC-1D5 for
charging the battery.
USB port (Transmitter right side)
*This is for factory use only.
19
<Before Use>
To Next Page
Loading...
