●Return to Linkage Menu
● Touch the [Model Type] button in the Linkage Menu to
call the setup screen shown below.
Model Type
This function selects the model type from among airplane, helicopter, and
glider.
(The display screen is an example. The screen depends on the model type.)
Seven types of main wings and three types
of tail wings are available for airplanes. Seven
swash types are available for helicopters. Seven
types of main wings and three types of tail wings
are available for gliders. Functions and mixing
functions necessary for each model type are set in
advance at the factory.
Note: The Model Type function automatically
selects the appropriate output channels, control
functions, and mixing functions for the chosen model
type. When the Model Type Selection command is
accessed, all of the data in the active memory is
cleared. Be sure that you don’t mind losing this data,
or back it up to another memory using the copying
functions.
Model type selection
1. Call the Type select screen by touching the
model type, wing, tail, swash type, or other
type button.
2. Select the type you want to set, and execute
type selection by touching [Yes] at the
confirmation screen. (When you want to
cancel model type selection, touch [No].)
53
<Linkage Menu>
To Next Page
Loading...
