EasyManua.ls Logo

FUTABA 14MZ - Camber Mix; Adjusting AFR;D;R Rates for Camber

FUTABA 14MZ
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AIR BRAKE
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
ELEVATOR
(ELEVATOR 2)
V-TAIL
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
RUDDER 2
Winglet
RUDDER 1
RUDDER
(RUDDER 2)
Winglet
at Flying wing at Flying wing
( )
( )
ELEVATOR ELEVATOR 2
(AILERON 6)
Camber Mix
This mixing adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
ELE to Camber
This mixing is used when you want to the mix
camber aps with elevator operation. Lifting force
can be increased at elevators up. [Airplane/glider,
2 ailerons or more]
Camber FLP to ELE
This mixing is used to correct for attitude changes
when the camber aps are being used. [Airplane/
glider, 2 ailerons + 1 ap or more]
Butter y (Crow)
This function is used when powerful brake operation
is necessary. [Glider, 2 ailerons or more]
Trim Mix 1/2
The ailerons, elevators, and aps trim offset rate can
be called by switch or condition selection. [Glider, 2
ailerons or more]
Airbrake
This function is used when airbrakes are necessary
when landing or when diving, etc. during ight.
(Airplane, general)
Gyro
This is dedicated mixing when a GYA Series gyro is
used. [Airplane/glider, general]
V-tail
This function adjusts the elevators and rudder of
V-tail models. [Airplane/glider, V-tail speci cations]
Ailevator
This function adjusts the elevators and ailerons of
models with elevator speci cations. [Airplane/
glider, elevator speci cations]
Winglet
This function adjusts the left and right rudders
of winglet models. [Airplane/glider, winglet
speci cations]
Motor
The operation speed when the motor of F5B and
other EP gliders is started by switch can be set. [EP
glider, general]
RUD to ELE
This function is used to correct roll maneuvers, knife
edge, etc. of stunt planes. [Airplane, general]
Snap roll
This function selects the snap roll switch and adjusts
the steering angle of each rudder. Servo speed can
also be adjusted. [Airplane general]
Multi Engine
This function adjusts the throttles independently
when using a multi engine model. (Maximum 4
engines) [Airplane, general]
81
<Model Menu (Airplane/Glider Functions)>
(AILERON 5)
AILEVATOR

Table of Contents

Other manuals for FUTABA 14MZ

Related product manuals