Waking the Transceiver from Low Power Mode
Out of the box, the transceiver is in low power mode. You must wake the transceiver from low power mode to
pair and connect to it.
Select an option:
• Install the transceiver on the first-stage regulator, and gradually open the tank valve to pressurize the
regulator.
NOTE: This option is not available for Bluetooth
®
pairing. Bluetooth technology is disabled when the
transceiver is pressurized.
• Twist the battery cover counter-clockwise 270 degrees, wait 30 seconds, then twist the battery cover
clockwise until it is secure.
The transceiver plays a tone when it wakes from low power mode and is ready to connect to your Descent
watch (Pairing the Transceiver with a Descent Watch, page9) or phone.
Pairing the Transceiver with a Descent Watch
Before you use the transceiver for the first time, you must pair it with the a compatible Descent watch using
ANT
®
technology.
1 Wake the transceiver from low power mode (Waking the Transceiver from Low Power Mode, page9).
2 On your Descent watch, hold MENU, and select Dive Setup > Dive Network & Air Integration > Transmitters >
Add New.
The watch starts searching and displays a list of nearby transceivers.
3 From the list of transceivers, select the transceiver ID you want to pair.
The transceiver ID is printed on the housing.
When the pairing process is complete, the transceiver begins sending data, and it is ready to use on a dive. The
next time the transceiver and watch are turned on and within wireless range, they connect automatically when
you start a dive.
If you are diving with a group, you can pair up to 8 Descent transceivers with the watch.
Diving 9
To Next Page
Loading...
Need help?
General
