Garmin G1000 Line Maintenance Manual

______________________________________________________________________________
____________________________________________________________________________
LMM for the Kodiak 100 Page 4-73
190-02102-00 Rev.4
4.7.7.2 Miscellaneous Radar Faults
Table 4-11. Possible Radar Faults
Symptom Possible Cause Recommended Action
Radar audibly noisy
during ground operation.
Excessive gear train
noise or radome
interference.
• Remove radome.
• Inspect interior surfaces of
the radome for contact with
the radar dish. Correct
interference by adjusting or
replacing radome.
• If no radome interference is
found, perform the
following:
1. Turn on the system.
2. Select the radar page
on the MFD.
3. Press the following
softkeys in the
following order: 7, 9,
9, 7.
4. Press the MODE
softkey
5. Press the TEST
softkey. The radar
dish will begin
scanning, but it will
not be transmitting.
• Test the horizontal and
vertical modes to exercise
the gear train and evaluate
for noise.
• If excessively noisy, replace
the GWX.
Uncontrolled if Printed

Garmin G1000 Specifications

General

Display Type	LCD
Primary Flight Display (PFD)	Yes
Multi-Function Display (MFD)	Yes
Terrain Awareness	Yes
Autopilot Integration	Yes
Integrated Flight Deck System	Yes
Weather Radar	Optional
Traffic Advisory System (TAS)	Optional
Terrain Awareness and Warning System (TAWS)	Yes
Resolution	1024 x 768 pixels
Weather Data	Yes
Navigation	Yes
AHRS	Yes
Air Data Computer (ADC)	Yes
Interfaces	ARINC 429, RS-232
Certification	TSO certified
Traffic Information	Optional (requires ADS-B or TCAS)