A
PPENDIX
D -
Security Commands
Security Options
DS2000-TS Administrator’s Guide
D - 7
D.5 C
ONSOLE
M
ONITOR
The Console Monitor functions allow the user to display the console monitor log and to configure which
parameters will be logged. The Console Monitor Functions menu (Figure D-7) is found in the Security
Functions menu by selecting <4> Console Monitor.
Figure D-7. Console Monitor Functions Menu
From the Console Monitor Functions menu, selecting <1> Access Log displays the Console Access Log
(Figure D-8). This log provides the following information:
•
Date and time the event occurred
•
The event that occurred (see Table D-2 for a list of possible events)
•
The UserID, if it can be determined, of the user that caused the event
•
The address, if it can be determined, of the user that caused the event
•
The local DS2000-TS port over which the console session is transmitted. For example,
“Console” for the physical console port or “728” for a telnet session using the first virtual
port.
After a screen of information has been displayed, the message “Press <CR> for More:” appears. When all
information has been displayed, the message “Enter Y<RET> to clear the system event log, otherwise
N<RET>:” is displayed. Enter Y to clear the log and exit; enter N to exit the log without clearing the
information.
*** Console Monitor Functions ***
1 - Access Log Display console monitor log
2 - Configuration Configure console monitor log
Enter command number:
__________[DynaStar_11]___________
Terminate input with <RET> Press ESC to return to previous menu
To Next Page
Loading...
Need help?
General
